Price:
US$10.86

Free Shipping

MC2130 V1.0 Ultra-silent 256 High Subdivision Stepper Motor Driver with Red Heat Sink for 3D Printer Part

Compatibility

To confirm that this part fits your vehicle, please enter your vehicle's details below.

  • Year:

    Select

    • Make:

      Select

      • Model:

        Select

        • Submodel:

          Select

          • Trim:

            Select

            • Engine:

              Select

              • Clear All
              This part is compatible with 0 vehicle(s).
              Show all compatible vehicles
              This part is compatible with 1 vehicle(s) matching
              This part is not compatible with
              Recent searches

                • Year
                • Make
                • Model
                • Submodel
                • Trim
                • Engine

                  Features: 
                   
                  1. 1.2A two-phase stepper motor single-phase current (peak 2.5A); adjustable motor operating current; 
                  2. Support two control methods: Step / DIR interface and SPI interface control 
                  3. Motor input voltage range: 4.75 ~ 46V 
                  4. Logical interface input voltage: 3 ~ 5V 
                  5. 256 subdivision; 
                  6. Maximum efficiency and optimum motor torque operation without noise; 
                  7. High-precision sensorless motor load detection; 
                  8. Reduce energy consumption by 75%; 
                  9. High load drive with no step out; 
                   
                  Specifications: 
                   
                  – Model: TMC2130 
                  Interface: Step/Dir or SPI 
                  Configuration: CFG Pins or SPI 
                  Native Microsteps: up to 1/256 
                  Microsteps: 1/256 
                  Logic Voltage VIO: 3-5V 
                  Motor Voltage VM: 5.5-46V 
                  Motor Phase Current: 1.2A RMS, 2.5A Peak 
                  RDSon: >=0.5 Ohm 

                  Package Included:

                  1 x TMC 2130 V1.0 stepper motor driver

                  MC2130 V1.0 Ultra-silent 256 High Subdivision Stepper Motor Driver with Red Heat Sink for 3D Printer Part
                  Drive current algorithm and regulation:

                   
                  1. Vref measures the voltage of Gnd and the middle end of the potentiometer.
                  2. Do not connect the motor when measuring voltage, otherwise it will easily burn the drive.
                  3. Turn on the power when measuring voltage. Do not connect USB power only.

                  Note:
                  Please pay special attention to the direction, do not insert it.
                   
                  Instructions for use:
                   
                  1. When using on the printer control board, please keep the 3 jumper caps under the socket.
                  2, because of the chip characteristics, must do a good way to heat! The heat sink is directly attached to the PCB. Pay attention to the direction of the heat sink. Otherwise, the heat sink and each pin will be connected together to cause a short circuit. For details, refer to the following figure.
                  3. The motor direction is exactly the opposite of A4988 and DRV8825. If you want to replace the A4988 directly, please adjust the firmware or adjust the motor connection.

                  Leave a Comment