Price:
US$48.99
Free Shipping
24V-48V 350W Brushless Motor Controller with LCD Display for Scooter E-Bike
Compatibility
To confirm that this part fits your vehicle, please enter your vehicle's details below.
-
Year:
Select
-
Make:
Select
-
Model:
Select
-
Submodel:
Select
-
Trim:
Select
-
Engine:
Select
- Clear All
This part is compatible with 0 vehicle(s).
Show all compatible vehicles
Show all compatible vehicles
This part is compatible with 1 vehicle(s) matching
This part is not compatible with
Recent searches
- Year
- Make
- Model
- Submodel
- Trim
- Engine
Specifications:
Brushless Motor Controller
Voltage:DC 24V/36V/48V
Low volts:DC 19V/29V/40V
Power:350W
Current:15A
Quiescent Current:22Ma
Angle:120/60
Material: Plastic + LCD + Metal
Controller Size:86x53x30MM
Features
– OVER-HEAT PROTECTION: Power will turn off when over-heat, and restart if the temperature is normal.
– OVER-LOAD PROTECTION: When overload happens,the motor stall more than 2 seconds, the controller will cut off the current out-put to protect the motor and battery.
– DUAL MODE: If the hall motor sensors are broken, controller will operate to None-Hall mode.
– EABS Function:better brake,extend the riding mileage without damaging the motor.
– LOW-VOLTAGE PROTECTION FUNCTION helps to extend the battery life.
– BRUSHLESS CONTROLLE: working silently and sensitive.
Self-learning matching steps:
– Connect Motor Phase Line and Hall Motor Phase line
– Connect the battery
– Link Two green learning lines together
– Connect the LCD/Smart Display and turn it to the highest level
THE MOTOR WILL ROTATE AFTER SELF-STUDY.
– If it rotates reversely, disconnect the learning line directly, and then plug it in, it will then rotate forward.
– Keep rotating forward for about 20 seconds, then directly disconnect the learning line.(DO NOT TURN OFF THE SWITCH)
– If it learns successfully which means the learning line will not be needed anymore,you can test the motor by plugging in the throttle.
Display:
Material: ABS +High Hardness Acrylic
Voltage:DC 24V/36V/48V
Cord Length:180cm
LCD Display Size:91x54x14MM
Note:
– Keep pressing 3 seconds for turning on/off
– SPCP between Display and Controller, could not match other controllers
Notes
– Turn off the power before wiring, and connect each wire as shown in the wiring diagram.
– The controller should be installed in a place where is ventilated, waterproof, and shockproof.
– The controller connector should be plugged in, and it is forbidden to reverse the positive and negative terminals of the controller power supply.
– LCD/Smart display comes with mount ,suitable for 22mm handlebar.
– Suitable for LITHIUM BATTERY type electric bicycles
Package Includes:
1 x Motor Controller
1 x LCD Display