Free Shipping

5110 84×48 LCD Display Module White Backlight For Arduino UNO Mega Prototype


To confirm that this part fits your vehicle, please enter your vehicle's details below.

  • Year:


    • Make:


      • Model:


        • Submodel:


          • Trim:


            • Engine:


              • Clear All
              This part is compatible with 0 vehicle(s).
              Show all compatible vehicles
              This part is compatible with 1 vehicle(s) matching
              This part is not compatible with
              Recent searches

                • Year
                • Make
                • Model
                • Submodel
                • Trim
                • Engine


                  5110 LCD Module, Arduino Compatible
                  You will Need: ( NOT Included in this Listing ! ) Set of Two 1K Resistors      ( For Safe Operation ) Set of Four 10K Resistors   ( For Safe Operation )

                  Pin Connections:

                  1. RST——— reset.
                  2. CE————chip selection.
                  3. DC———–data/commands choice.
                  4. DIN———–serial data line.
                  5. CLK————serial Clock Speed.
                  6. VCC———-Power, 3.3V (Positive).
                  7. LIGHT——— backlight control terminal.
                  8. GND———–power negative.


                  Power supply voltage: 2.7V- 3.3V
                  Backlight Power Supply Voltage: 3.3V MAX
                  43.6mm x 43.1mm(width X height)
                  84 x 84 dot matrix LCD,can show 4 lines of characters, 12 Characters Per Line


                  Uses Serial Peripheral Interface (SPI) to communicate with the microcontroller, only 8 signal lines including power and GND. Support different types of MCU (MicroController Unit) , such as Arduino, PICAXE, ARM, Raspberry PI etc. Transfer rate up to 4Mbps,can full speed write display data without waiting time.
                  LCD controller/driver chip has been bound to LCD chip so the overall footprint of the LCD Module is Kept as small as possible.
                  Has TWO Rows where header pins can be soldered for greater flexibility of use!
                  Low power supply, the working current in normal situation is lower than 200μA,and has power-down mode.

                  Package included:

                  1 x 84×48 5110 LCD Module with White Backlight

                  Leave a Comment