Free Shipping

Holybro Kakute F7 HDV Flight Controller STM32F745 with Barometer compatible for DJI FPV 30.5×30.5mm 8g


To confirm that this part fits your vehicle, please enter your vehicle's details below.

  • Year:


    • Make:


      • Model:


        • Submodel:


          • Trim:


            • Engine:


              • Clear All
              This part is compatible with 0 vehicle(s).
              Show all compatible vehicles
              This part is compatible with 1 vehicle(s) matching
              This part is not compatible with
              Recent searches

                • Year
                • Make
                • Model
                • Submodel
                • Trim
                • Engine


                  HolyBro Kakute F7 HDV is designed to work with the DJI FPV VTx module. The GH port available on the
                  board makes it much more convenient for you to connect HolyBro Kakute F7 HDV to the DJI FPV VTx, for
                  both signal and power.


                  MCU: STM32F745 32-bit processor
                  Barometer: BMP280
                  USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)
                  6 hardware UARTS (UART1,2,3,4,6,7)
                  All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on
                  any UART without “uninvert hack”.
                  Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not
                  TF card for Blackbox logging
                  Dimensions: 35x35mm
                  Mounting Holes: Standard 30.5mm square to center of holes
                  Weight: 8g


                  • Supports Betaflight, Butterflight, and Cleanflight.
                  • High-performance / low-noise IMU. MPU6000 with 6-axis gyro and accelerometer.
                  • Ready for autonomous flight: Integrated BMP280 barometer and SCL/SDA for use with external
                  GPS/magnetometer units.
                  • Dedicated bootloader button for easy firmware flashing.
                  • Low-profile design fits into even very compact frames.
                  • Input voltage 7v to 42v. Power the board directly from the flight pack, up to 6S (on “B+” pad
                  • Automatic voltage monitoring. No need to run a separate vBat wire for voltage monitoring; the
                  KAKUTE F7 HDV monitors voltage directly from the power supply.
                  • Filtered voltage output for clean, noise-free video. 2 On-board regulators output 5V and 8V. 5V
                  output up to 1.5A to power peripherals such as receiver, FPV camera, or LED strip. 8V output up
                  to 2A to DJI FPV VTx.
                  • Supports BLHeli pass-through for easy ESC upgrade and configuration.

                  Package Included:
                  1 x Kakute F7 HDV Flight Controller 

                  Leave a Comment