Price:
US$75.00

Free Shipping

Holybro Tekko32F3 Metal 65A BLheli_32 4-6S 4in1 ESC DShot1200 w/ F3 MCU & Current Sensor for RC Drone FPV Racing

Compatibility

To confirm that this part fits your vehicle, please enter your vehicle's details below.

  • Year:

    Select

    • Make:

      Select

      • Model:

        Select

        • Submodel:

          Select

          • Trim:

            Select

            • Engine:

              Select

              • Clear All
              This part is compatible with 0 vehicle(s).
              Show all compatible vehicles
              This part is compatible with 1 vehicle(s) matching
              This part is not compatible with
              Recent searches

                • Year
                • Make
                • Model
                • Submodel
                • Trim
                • Engine

                  Holybro Tekko32F3 Metal 65A BLheli_32 4-6S 4in1 ESC DShot1200 w/ F3 MCU & Current Sensor for FC Drone FPV Racing

                  Introducation:
                  New BLHELI32 ESC with F3 MCU, give more smooth control and faster responding speed. using metal case mosfet for better Heat dissipation. 
                  We tested in short time on 220A intotal. The actual performance will only limited by the air flow.

                  Specification:
                  Brand Name: Holybro
                  Model: Tekko32F3 Metal 
                  Item Name: 65A BL_32 32Bit DShot1200 4 in 1 ESC

                  Con. Current: 65A
                  Peak Current: 80A
                  Input Voltage: 4-6S Lipo Support
                  Ext. cap needed for 6s (470uf 35v for 6s usage)
                  – F3(M4 Core) MCU, Runs BLHELI32 firmware, the MCU works at 108Mhz
                  Size: 42x42mm
                  Mounting Hole: 30.5×30.5mm
                  Weight: 12g

                  Notice:
                  1. The air flow is very import if you want to run this 4in1 in high current.
                  2. The input cable(from lipo to 4in1), should be good soldered, and at least 12AWG
                  3. Please use non-metallic isolation standoffs (marked in red in the diagram above) for the mounting holes on the ESC.
                      Because mounting holes and motor pad are connected.

                  Features:
                  – The 4in1 has onboard analog current sensor, and TLM function(then no current reading over TLM)
                  – Using metal case mosfet for better Heat dissipation
                  – BLheli_32 firmware, support Oneshot, Multishot, Dshot150, DShot300, DShot600 and DShot1200

                  Package Included:

                  1x Tekko32 F3 Metal 4in1 ESC 
                  1x 470uF 35V Electrolytic Capacitor
                  1x 8pin to 8pin 1mm pitch 65mm Cable
                  1x 8pin to 8pin 1mm pitch 25mm Cable 





                  Leave a Comment