Free Shipping

Original Airbot F7 Flight Controller AIO Betaflight OSD 5V BEC 3-6S for RC Drone FPV Racing


To confirm that this part fits your vehicle, please enter your vehicle's details below.

  • Year:


    • Make:


      • Model:


        • Submodel:


          • Trim:


            • Engine:


              • Clear All
              This part is compatible with 0 vehicle(s).
              Show all compatible vehicles
              This part is compatible with 1 vehicle(s) matching
              This part is not compatible with
              Recent searches

                • Year
                • Make
                • Model
                • Submodel
                • Trim
                • Engine

                  Original Airbot F7 Flight Controller AIO Betaflight OSD 5V BEC for RC Drone

                  Brand Name: Airbot
                  Item Name: F7 Flight Controller AIO OSD BEC
                  MCU: STM32F722 
                  Input Voltage: 3-6S Lipo 
                  – Betaflight OSD
                  – BEC: 5V @ 2A
                  Size: 36x36mm
                  Mounting Hole: 30.5×30.5mm


                  • STM32 F722 MCU, Runs Betaflight firmware
                  • ICM Gyro Over SPI Bus
                  • 30.5*30.5 mm Mounting holes
                  • Supports Lipo direct plugin (3-6S)
                  • Supports 5V 2A BEC output (Buck)
                  • STM32 controls OSD chip over SPI in DMA mode (Betaflight OSD)
                  • More UARTs (6xUARTs)
                  • Supports camera control function
                  • Supports ext. Gyro box
                  • Onboard 128Mbit(16MB) flash for balckbox

                  Resources Setting:

                  Function Solder Pad
                  Silk Screen
                  Resources MCU Pin Notes
                  SBUS SB  RX 1  PA10  
                  DSM2 TX1  TX 1  PA9  CLI: serialrx_halfduplex set to ON
                  Smart Audio VTX  S/A  TX 5  PC12  
                  Smartport  S.P  TX 4  PA0  
                  ESC Telemetry  TLM  TX 2  PA2  CLI: set esc_sensor_halfduplex = ON
                  Camera Control  CC    PA8  
                  SDA  SDA  I2C1_SDA  PB9  Ext. Pull up needed
                  SCL  SCL  I2C1_SCL PB8  
                  GPS  RX6/TX6  UART 6  PC6/7  
                  WS2812B LED  LED    PA15  
                  Buzzer  Bz-/Bz+    PB0  

                  Package Included:
                  1x Airbot F7 Flight Controller 

                  Leave a Comment