US$44.49 ~ 46.49
To confirm that this part fits your vehicle, please enter your vehicle's details below.
- Clear All
Show all compatible vehicles
1. Switching power supply, convert AC 110V/220V to DC 0-24V(0-20A) / DC 0-36V(0-15A) / DC 0-48V(0-10A) 480W.
2. Come with two knob switches: a 0-24/36/48V DC fully adjustable switch and a 0-10/15/20A fully current adjustable switch.
3. Dual input voltage, built-in 110V AC/220 V AC toggle switch(on the side), the defualt voltage is 220V DC.
4. Dual digital display the real-time output DC voltage and current.
5. Smart device surge protection for shortage, overload, overvoltage. And built-in intelligent temperature control cooling fan.
6. Wide input voltage range, widely used in battery charging, Industrial automation, LED light strip display, student experiment,
Product: Switching Power Supply
Input Voltage: AC 110V/220V
A: DC 0-24V 0-20A
B: DC 0-36V 0-15A
C: DC 0-48V 0-10A
Input Frequency Range: 50/60Hz
Modulation Mode: PWM
Output Start Time: ≤2S(120V AC), ≤1S(230V AC)
Output Hold Time: ≥10mS(120V AC), ≥20mS(230V AC)
Working Temperature: -10℃~+60℃
Working Humidity: 20% ~ 90%RH (no condensation)
Size: Approx. 215X115X50mm
Gross Weight: Around 900g
1. This product can work normally only when the input voltage is AC 110V or AC 220V, make sure that the local Using voltage is AC
110V or AC 220V before you place an order.
2. The max current is 10A/15A/20A, so any device with less than 10A/15A/20A current can be used, any device with a current 10A/15A/20A
upper cannot be used.
1 X Switching Power Supply
9 X Terminals
1 X Current Regulating Insert
tighten with a screwdriver (at this time, connect to the AC power), and then the voltage digital display shows 0.00V, and the
current shows the current current parameter.
synchronously with the digital display. 0-20A/0-15A/0-10A can be adjusted in the whole process.
voltage is about 0.90V, and the current is 0.00A.
shows the output voltage in real time), the current does not change. And the current reaches 95% of the current limiting parameter,
overload protection starts working.
not to swich the current knob because the limited current parameter will change when you witch the current knob.
If there is no need for current limiting, use the general equipment, without the above operation, pull the pull switch in the lower left corner
to the right "open (use)" gear, and turn the (current adjustment knob) clockwise to the top. The maximum current limit at this time is 20A/
15A/10A, at this time the power supply parameter is the output 0-24V 20A/0-36V 15A/0-48V10A, which is equal to a 0-24V 20A /0-36V 15A/
0-48V 10A switching power supply.