Price:
US$19.99

Free Shipping

1.2g Happymodel Speki+ Micro 2.4G 12CH Receiver Compatible DSM2/DSMX/SRXL With Power Amplifier RSSI Ready for RC Drone

Compatibility

To confirm that this part fits your vehicle, please enter your vehicle's details below.

  • Year:

    Select

    • Make:

      Select

      • Model:

        Select

        • Submodel:

          Select

          • Trim:

            Select

            • Engine:

              Select

              • Clear All
              This part is compatible with 0 vehicle(s).
              Show all compatible vehicles
              This part is compatible with 1 vehicle(s) matching
              This part is not compatible with
              Recent searches

                • Year
                • Make
                • Model
                • Submodel
                • Trim
                • Engine

                  Happymodel Speki+ Micro 2.4G 12CH Only 1.2g Receiver Compatible DSM2/DSMX/SRXL Protocol With Power Amplifier RSSI Ready

                   

                  Speki+ is the upgrade DSM2/DSMX/SRXL protocol compatible Micro 2.4Ghz receiver, it comes with PA module, longer range and stable signal transmission, with RSSI telemetry. You can get the RSSI from Betaflight OSD

                   

                  Specifications:

                  Brand: Happymodel

                  Model Name: Speki+

                  Weight: 1.2g

                  Dimension: 20mm*12.4mm*5mm

                  Support protocol: DSM2/DSMX

                  Output Signal configuration: SRXL(Set Spektrum2048/SRXL for the serial receiver provider)

                  Antenna connector: I-PEX MHF3

                  Antenna length: 70mm

                  Input voltage: 3.6v~13v

                  Input current: 100ma

                  Channels: Max12ch(usually channel 12 is used for RSSI)

                  Telemetry output:

                  For the radio transmitter which come with Opentx and equipped with DSM2/DSMX module, the RSSI display as the value of Hold from the radio screen. And the input voltage is display as the value of A2 .

                  Sensitivity: -101dBm

                  Return transmission power: 18dBm

                   

                  Bind procedure:

                  1. Press and hold the bind button of the receiver, then power on for the Speki+ receiver.(Usually we can connect the receiver to the flight controller, and plug the usb to power up for the receiver)

                  2. The Red LED start to blinking fast, this indicate the receiver is in bind mode

                  3. Make your radio transmitter get into bind mode. If the red LED on the receiver turned off ,this indicate bind is successful then quit bind mode for the radio transmitter

                  4. The red LED on the Speki+ receiver is solid , now the radio transmitter and the receiver are working fine.

                   

                  Note:

                  Make sure the “Telemetry” was enable from the Betaflight Configurator, otherwise the receiver will not work.

                  Please set AUX8 for the RSSI Channel

                  The receiver signal should be connected to idle port TX(not rx port) and enable Serial_rx for this UART port. If you connect to TX1 then you should enable serial_rx for UART1. 


                  Package Included:

                  1x Receiver

                  Leave a Comment