Free Shipping

48 Inch DC9-24V Three Color LED Strip Light Car Tailgate Pickup Turn Signal Reverse Brake Lamp


To confirm that this part fits your vehicle, please enter your vehicle's details below.

  • Year:


    • Make:


      • Model:


        • Submodel:


          • Trim:


            • Engine:


              • Clear All
              This part is compatible with 0 vehicle(s).
              Show all compatible vehicles
              This part is compatible with 1 vehicle(s) matching
              This part is not compatible with
              Recent searches

                • Year
                • Make
                • Model
                • Submodel
                • Trim
                • Engine

                  Input voltage: DC9-24V
                  Power: 0.2W/LED
                  Light source: SMD2835
                  Quantity of LEDs:
                  48 yellow+48 red + 24 white leds (120 leds)
                  Waterproof: yes
                  Beam angle: 180 degree
                  Connection wires: 5 wires
                  Lighting effects: 4: turn left, turn right, braking, daytime running,brake left, brake right
                  Applicable car brands: universal, suitable for all car brands
                  Length: 120cm(48")
                  If your purchased LED Tailgate light bar with reverse light option proceed with your installation using the flowing steps:
                  Carefully remove one of your tail light assemblies.
                  Power your truck on and pit it into reverse, So that your factory reverse lights are illuminated. It is imperative that you set the parking brake.
                  Return a volt meter, find the positive 12volt wire that powers your reverse light.
                  Using a volt meter , find the positive 12volt wire that powers your reverse light.
                  Once you have found your factory reverse light wire , use a wire stripper to cut and strip the wire.
                  Run the light bar’s whiter reverse wire to your factory reverse wire.
                  Use a butt connector to connect the tailgate bar’s white reverse wire to the trucks factory reverse wire. You can also solder or use a tape connector to secure this connection.
                  Now you can re-install your tail light assembly and tailgate. And test your tailgate light bare to full functionality.
                  Please don’t connect it on the flasher of vehicle.
                  Package included:
                  1x 48" LED tailgate strip light 

                  Leave a Comment