Price:
US$21.99

Free Shipping

Buy Now
Hantek P2301B 300MHz 100MΩ Oscilloscope Probe BNC Protective Cap Scope Clip Probe

Compatibility

To confirm that this part fits your vehicle, please enter your vehicle's details below.

  • Year:

    Select

    • Make:

      Select

      • Model:

        Select

        • Submodel:

          Select

          • Trim:

            Select

            • Engine:

              Select

              • Clear All
              This part is compatible with 0 vehicle(s).
              Show all compatible vehicles
              This part is compatible with 1 vehicle(s) matching
              This part is not compatible with
              Recent searches

                • Year
                • Make
                • Model
                • Submodel
                • Trim
                • Engine

                  Features:
                   
                  1. The main body is grounded, which is smoother and reliable.
                  2. The probe is fully grounded in the form of injection molding, which greatly increases the service life of the grounding wire.
                  3. BNC (Q9) material, equipped with an insulating sheath on the outside of the BNC, which improves the safety level.
                  4. The probe is commonly used in oscilloscopes on the BNC interface on the market.

                  Specification:
                   
                  Product model: P2300B
                  Product Name: Oscilloscope Probe
                  Product weight: 0.075kg
                  Bandwidth: 1-300MHz
                  Maximum input voltage: 600V
                  Attenuation ratio: 100X
                  Input resistance: 100MΩ

                  NOTE:

                  When connecting the probe to any input channel for the first time, a probe check is required to match the probe to the input channel. Probes that are not compensated or compensated for deviations can cause measurement errors or errors.
                  1. Set the software selection X10. Set the probe attenuation factor X10 and connect the probe to the CH1 channel. If using a hook probe, make sure the probe is in close contact with CH1. Connect the probe tip to the signal output connector of the probe compensator, and the reference lead clip is connected to the ground connector of the probe compensator.
                  2. Check the shape of the displayed waveform to determine if the probe compensation is correct, turn on CH1, and press the “AUTO” button.
                  3. Check the shape of the displayed waveform to determine if the probe compensation is correct.

                  Package includes:

                  1 X P2300B Oscilloscope Probe

                  Details pictures: 







                  Leave a Comment