Free Shipping

Happymodel CrazybeeX DXS F4 1-2S AIO 5in1 Flight Controller Built-in VTX/ DSM2 DSMX Receiver/ESC/OSD


To confirm that this part fits your vehicle, please enter your vehicle's details below.

  • Year:


    • Make:


      • Model:


        • Submodel:


          • Trim:


            • Engine:


              • Clear All
              This part is compatible with 0 vehicle(s).
              Show all compatible vehicles
              This part is compatible with 1 vehicle(s) matching
              This part is not compatible with
              Recent searches

                • Year
                • Make
                • Model
                • Submodel
                • Trim
                • Engine

                  CrazybeeX series flight controller is the first 4in1 AIO flight controller which could handle 2s. 

                  The CrazybeeX DXS V1.0 is the newest member which is the first flight controller built-in DSM2/DSMX compatible SPI Receiver.

                  It's a better upgrade for reduce the weight of your brushless whoop if you are using Spektrum transmitter.  Best upgrade flight controller for Mobula6/Mobula6HD DSMX version .

                  Flight controller MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
                  Sensor: MPU-6000(SPI connection)
                  Board size: 28.5 * 28.5MM
                  Power supply: 1S-2S battery input (DC 2.9V-8.7V)
                  Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
                  Built-in Betaflight OSD(SPI Control)
                  Built-in 5.8G VTX
                  Built-in SPI Frsky receiver support D8/D16
                  Built-in 5V 1A BEC
                  Built-in voltage detection
                  Firmware version Customized Betaflight4.3.0 S411
                  Onboard 4in1 ESC MCU upgraded to EFM8BB21
                  Power supply: 1-2S LiPo/LiPo HVCurrent: 5A continuous peak 6A (3 seconds)
                  Support BLHeliSuite programmable
                  Factory firmware: S_H_50_REV16_7.HEX
                  Default protocol: DSHOT600
                  Onboard DSM2/DSMX SPI receiver SPI BUS receiver DSM2/DSMX compatible
                  Channels: Max 12ch
                  Failsafe support
                  No ground interference ( Transmitter and receiver 1 m from the ground): 200m~300m
                  RSSI enable(show on the goggles)
                  Onboard 5.8g VTX Output power: 25mw
                  Frequency: 40CH
                  Input voltage: 3.3V~5.5V
                  Current consumption: 300mA(type)
                  Frequency: 5.8GHz 5bands 40 channels
                  With Race band
                  Smartaudio ready
                  Default vtx_power should set to be “3”
                  Onboard Voltage and Current detector Voltage Meter scale “110”
                  Amperage Mete scale “1175”

                  Notice: Recommend Betaflight configurator 10.7.0 version
                  SPI Receiver option: Spektrum

                  Bind procedure:

                  1. Plug the USB then press the bind button, the red LED at the bottom of the flight controller will blinking fast , this indicate the SPI DSM2/DSMX receiver is in bind mode.
                  2. Plug the USB then connect to Betaflight configurator, move to the CLI tab , then type “bind_rx”, the red LED at the bottom of the flight controller will blinking fast too , this indicate the SPI DSM2/DSMX receiver is in bind mode.

                  Package Included:

                  1* CrazybeeX DXS AIO 5in1 F4

                  Leave a Comment