Free Shipping

Upgraded 20A 12V/24V Auto Volt/Amp/Temp Display Display PWM Solar Panel Charge Controller


To confirm that this part fits your vehicle, please enter your vehicle's details below.

  • Year:


    • Make:


      • Model:


        • Submodel:


          • Trim:


            • Engine:


              • Clear All
              This part is compatible with 0 vehicle(s).
              Show all compatible vehicles
              This part is compatible with 1 vehicle(s) matching
              This part is not compatible with
              Recent searches

                • Year
                • Make
                • Model
                • Submodel
                • Trim
                • Engine

                  With Voltage & Current & Temperature Display
                  Support detection for the Vpmax for the panel, Not just charging voltage.
                  – 32 bit MCU high-speed kernel ARM CORTEX, CPU running speed 72MHz
                  – 13 new function LCD menu, Adjustable charging parameters.
                  – One-click to restore factory Settings, One-click to reboot.
                  – Fully 3-stage PWM charge management.
                  – Build-in short-circuit protection,open-circuit protection,reverse protection, Over-the-load protection.
                  – ST/IR/ Infineon imported dual MOS MOSFET for anti-reverse circuit
                  – 1oZ copper foil thickness, applicable in -35℃~60℃, high-temperature protection.
                  – Use ±1% high precision resistance, the high-temperature solid-state capacitor on the PCB board with thickness over 2mm. 
                  – Ultra-low power consumption 12mA@12V.
                  Specification of 10A Controller:
                  Rated Voltage:12/24V Auto-Adaptive
                  Rated Current:10A
                  Max.PV Voltage: 50V
                  Applicable Pmax & Voc in 12V Solar System: 130W, 15-25V
                  Applicable Pmax & Voc in 24V Solar System: 260W, 30-50V
                  Float charge:13.7V (defaul,adjustable)
                  Discharge stop:10.7V(defaul,adjustable)
                  Discharge reconnect:12.6V(defaul,adjustable)
                  Charge reconnect:13V
                  Voltage of open light:Solar panel 8V(Light lights delay)
                  Voltage of close light:Solar panel 8V(Light off delay)
                  USB output:2 way USB output,5V/2A(Max.)
                  Double USB 5V 2A
                  Operationg temperature:-35-60℃
                  Size: 132mmx70mmx32mm

                  Applicable Battery Type  B01: lead-acid battery (13.7V)
                   B02: lithium polymer battery (12.6V)
                   B03: lithium iron phosphate battery (14.4V)
                  About the Charging &
                  Dis-Charging Current Display
                   The controller is mainly designed for the high current solar system, The current may not display in 3 situations: Low-wattage panel, Weak sunlight, Low-wattage appliance.

                   The display is more accurate when the current is higher (>1A).
                  About the Temperature Display  Charging will stop at >80℃
                   Charging will restart at <70℃
                  System connection  1. Connect the battery to the charge regulator-plus and minus.
                   2. Connect the photovoltaic module to the regulator-plus and minus.
                  3. Connect the consumer to the charge regulator-plus and minus.

                  Package included:
                  1 x PWM Solar Charge Controller 10A
                  1 x User Manual

                  Leave a Comment